(1)
This experiment shows
total internal reflection.
You can see the light from the laser pointer going through the bottle,
and it goes right through the middle of this short piece of straw.
The light bounces around inside the stream of water, it cannot
get out until the stream breaks up, so the light ends up in the bucket.
|
|
(2)
Here is the version you can make yourself. In the small paper bag you can find:
→
- Rubber stopper
- Short piece of tube
- 2 clothespins
- Piece of gum
You need to provide:
- Cutting board
- Books or magazines
- Container to catch the water (optional)
- Funnel (optional)
|
|
(3)
First, remove the wrap-around label from the bottle.
Next, mark where you will cut a little hole. Choose the spot such that
on the opposite side of the bottle, there is clear plastic (no
leftover bits
of label or glue.
In the example,
the hole is about 2 inches up from the counter. Using the exacto knife,
start cutting the hole, a
little on the small side, and enlarge the hole carefully until you can push
the little tube about halfway in. Chew some gum and use that to make a
waterproof seal.
|
|
(4)
Now line up the laser pointer (or laser box). In the example, one clothespin
is used to turn the laser on and keep it on, and half of the other clothspin
makes a wedge so you can fine-tune the angle.
You need to find the right height, using a cutting board on the bottom
(because water will spill on the counter and you want to keep the books
or magazines dry), and then books or magazines so that the laser goes
into the middle of the little tube
|
|
(5)
Ready to go!
Fill the bottle to the top with water, and put the stopper in. This will prevent the water from starting to run out (why?).
Put the bottle back to where the laser goes through the bottle and into the
middle of the little tube.
Hold the bottle down and take off the stopper.
Watch the light end up in the bucket!
If you look closely, you can see the laser beam inside the water stream, and
bounce off the inside surface of the water, especially close to the bottle.
If you add a drop or two of milk, this becomes more visible.
Looks even better after dark
|
|
(P.S. In all these years, this was the first time that chewing
gum was the perfect material to use in a project.)
|